Yaesu FTM-400XDE - first run on car antenna

Well it wasn't really a proportionate test as the bands and repeaters were not as active as I'd have liked, though there were some QSOs going on I felt best that I not interrupt and put out calls on repeaters that were otherwise clear.

At my usual testing ground for all things radio at the top of the hill, access to GB3CD in the radio's "DN" mode (ie C4FM) was possible, though at the end of the second check the repeater switched to FM on transmit, thus putting the radio back into FM as well as the AMS was turned on, GB3CD appeared to also end-stop the meter on the display, indicating a good signal from it.  GB3IR was obviously going to work fine, I got a report that the audio was fine, though simplex would work better here.  GB3HG was busy, and was also good signal to me.

A few simplex QSOs, as I mentioned above, were going on, so I took this time to use that as a good reference for receive, the antenna pulling the signals in well, none of them into the red part of the s-meter but still very good signals.

Also, the APRS side was on and it was receiving with no issue whatsoever, I did not have my beacon on for the reason that I was not testing that side out and would prefer to be /m while doing so.

All this leaves now is the rig be installed in the car via a relay to protect the battery from being drained should I forget to shut the radio off, it also acts as a prompt that I can only use the radio with the key in the ignition, the relay I have chosen is a standard Bosch automotive relay that omits pin 87a as this would not be needed, the coil supply has already been assembled to the relay and this will be tapped from an IGN switched source, I was thinking the loom for my Parrot handsfree or even the stereo itself, though the latter is more difficult to repair, but either way it will switch the rig off with the ignition.

so far so good

73 de M6RSQ

System Fusion - follow up

So, today I made the trip all the way to Martin Lynch & Sons in Staines, and saw for myself what a wonderful showroom they have, and picked up the Yaesu FTM-400XDE, along with a Sirio magmount and a Diamond antenna (I forget the models of these without going out to the car, I had to stop at a services on the A1 in Peterborough as I am far too tired to drive at time of writing but should be back at the home QTH tomorrow afternoon.

This means I have not been able to play with the System Fusion side of things, what it does mean is that on my way home tomorrow morning I can pick up a micro SD card and somehow attempt to programme the rig when I get home.

So, when I make it home tomorrow I shall let you all know how I get on with it

and those new to Amateur radio or the hobby as a whole, don't let my previous post put you off, those people are a small minority and the rest of us are all very helpful and friendly and would love to hear more voices on the air

73 de M6RSQ

The not so nice people in the radio hobby

The vast majority of those in the hobby, licensed or not, that I have ever spoken to have always been nice to me and treated me with the utmost respect I come to expect from those in the hobby, sadly there are some that are not as nice, I've seen snippets of this on YouTube of how not to behave on the air, but there is always one licensed Amateur radio operator that stands out from even those, Chance Callahan KD0MXN, this is a young man that for years has held an ongoing grudge against myself and when I got my foundation license last year I thought maybe he would show some respect for me, alas this was not the case.

I would advise people to use caution if they ever encounter this callsign on the air, this young man is not a nice person at all and since 2008 had gone out of his way to make my life utter hell, and has told countless lies about me, why would a fellow Amateur radio operator do this? who knows, it comes as a sad day, and this is the day I actually got myself a new rig and mobile whip too, so it should have been a very good day but alas not to be, ruined by a fellow amateur operator who holds a grudge and claims a "restraining order" has been issued against me by someone, which I know not to be true as I have never been in a court room in my life, and that I allegedly almost drove someone to suicide, both these claims have no evidence and no grounds.

He also claimed in the past I gave his address out, all US callsigns automatically go onto QRZ.com, therefore it is public domain, just like the contents of the RSGB callbook here in the UK, though I forget if that lists calls and addresses.

Hopefully something good will come out of this, but we will see

73 de M6RSQ

System Fusion

As you may have worked out from some of my previous posts I am interested in making the step to System Fusion (Yaesu's C4FM digital voice system), and have had my eye on the Yaesu mobile rigs capable of this for some time, notably the FTM-100DE and it's more expensive sibling the FTM-400DE (now the FTM-400XDE), along with this as I plan to use the radio mobile no matter which one I get I will replace the mobile antenna with one of a better design, the current one, though fine for TX on 2m/70cm is not brilliant and was only meant as a stop-gap for my previous car until I could get a larger antenna, it's quality is showing with the Baofeng on the other end though it still transmits fine but I really don't want this for System Fusion,

So, a trip to an Amateur radio store is in order, but my current car has already thrown a spanner in the works by virtue of a damaged tyre that I have to get fixed, though I am already on to sorting that out and it should be done by Tuesday (with a swap of the spare to the opposite wheel) thus enabling me to go to the Amateur radio store of choice and see what they can do for me (if I can pay off the cost of the rig over a period of a few months I will be able to take one home with an antenna and an external speaker).

Not only am I interested in operating on C4FM with one of these rigs I am also interested in APRS as these rigs feature it, though from what I currently understand (though I could be wrong) is that the APRS does not transmit and allow voice transmission at the same time on the FTM-100DE meaning I would need the more expensive FTM-400XDE to do this as I'd like to keep up with the APRS side which I've not had chance to use for a while.

Anyway, I shall let you know how I get on and if I become the owner of one of the above mentioned Yaesu rigs, once it's in the car I should then be heard on System Fusion, there are at least 3 other club members so equipped for it, I might just be joining them soon

73 de M6RSQ

Shack computer upgraded to Windows 10

Before I get onto the post proper I better mention that despite my earlier post I had not got the Sirio GPE 5/8 antenna up and put on the air today as time ran out due to me looking for a missing washer and some tools and time running out as I did this, and the fact I may need a second pair of hands to help

So, the shack computer, starting out on Windows XP when it first went in, then a move to Windows 7 once Windows XP went EOL, and now it has gone on to Windows 10, which despite my worries actually runs OK, so far tested with it is Echolink, the software side of the shackcam runs but obviously with no video device it cannot display an image, that's a part of the shack refit to come.

Though it runs Windows 10 fine I plan to replace the CPU with a much better one than is currently fitted as the current one I believe is single-core and maxed out a lot on Windows 7, but it seems OK on Windows 10.

This also played havoc with my printer drivers as the printer exhibited symptoms that it had with my laptop, this is a driver issue and this was two fixes I needed to make for Windows 10, the other relating to Prolific PL2303 drivers (as these are very fussy about certain cables which may use "fake" PL2303 chips), of course Cortana is turned off as far as it can go.

So, outstanding to test on the shack computer are CHIRP, which I use for radio programming (though it showed issued with my Wouxun KG-UVD1P), logging software for Amateur use (I have a separate program for 11-metres which I have run briefly), the software TNC and some of the APRS related software, and the RTL-SDR software, any further issues can be addressed with a trip to PC World or Maplin for a new CPU and extra RAM

The machine still sees both sound cards so is good to go for anything else

73 de M6RSQ/26CT730

Sirio GPE 5/8 CB antenna

I have owned, for a number of years, a Sirio GPE 5/8 CB antenna that has sat unused since I bought it, today's plan is to see if I can install it on my temporary base with the antenna guyed on the base, then compare its performance with that of the T2LT, there will be a massive difference if both antennas were able to be mounted at the same height but in this instance the height at which the GPE 5/8 can be mounted is at the very top of the mast and would not be as high as the T2LT's radiating part, as the metal mast is replaceable should the worst happen (ie it bends under the antenna's weight upon install) this is not a huge loss as I can simply go to B & Q and replace it

with this antenna safety is higher priority as it is heavier than my T2LT and will be mounted lower down, both from a radio and physical point, the antenna is lower down the mast therefore exposure to RF is higher for anyone nearby, the coax may pose a trip hazard but I will try and raise this up should the antenna be successfully erected on the temporary base.

If this proves to be a success then I will attempt to get a few QSOs on it and will post later the outcome whatever happens

73 de 26CT730

Temporary antenna setup success

So, after all the planning the temporary antenna setup was a success, and today I was able to verify that my T2LT was indeed working and getting out fine, however I felt the mast would have been better guyed, as it is a temporary setup the guys would have to be removed each time the antenna was to come down, this is the next thing to work on.

So, the T2LT was confirmed working on UK19 after I got confirmation after doing the traditional "one nine for a rig check" on CB, I then turned my attention to EU27 USB to place calls, both before and after I went outside with the rig, however the band was completely dead, but at least I know my T2LT is working great, with the SWR on the antenna in the range of 1.5 on the meter or below this, making my life simple, the whole setup was removed within about 10 minutes and reduced back to component parts, the base and aluminium mast stay in a shed out the way as this part is the heaviest and transporting it up the stairs is a no-no, the rest of the antenna is in the flat, this being the T2LT itself, the fibreglass mast, and all the needed mounting hardware, which in this case was a bungee cord and some cable ties, but the news that it had indeed worked has made my day and the T2LT is ready for test number two, involving someone sitting in my "shack" operating the CB (again the Grant II) while I drive around with another CB with a reliable S-meter in the car (I can use either my Midland 42 Multi, Midland 78 Plus Multi B, or my Intek H-520 Plus as these all have reliable s-meters, the Moonraker FA5000 does not have a reliable s-meter at all and the TTI TCB-550 has no S-meter.

So, I finally know the T2LT works, but was not able to find out just how good it was working, I will update this in due course

73 de 26CT730